Dialogic DSI SPCI Network Interface Boards Programmer's Manual page 23

Dialogic
LOCAL 0xcf
LOCAL 0x2d
LOCAL 0x3d
After the LOCAL declarations, REDIRECT commands are added for modules
that run on the board so that messages destined for these modules are
transported via ssds (module_id = 0x20) and the device driver, to the board.
These REDIRECT commands are always required:
REDIRECT 0x71 0x20
REDIRECT 0x10 0x20
REDIRECT 0x8e 0x20
Further REDIRECT commands are required for protocols chosen to run on the
board. This typically includes MTP3 and one or more user parts. For example:
REDIRECT 0x23 0x20
REDIRECT 0x4a 0x20
REDIRECT 0x22 0x20
Next, ensure status indications issued from the board can arrive at a module
running on the host. (If this does not happen, the system will quickly run out
of available messages for inter-process communication).
Two module_id's (0xdf and 0xef) require redirection to a suitable process
running on the host. Initially these messages should be redirected to the
s7_log utility, which prints out a line for each message received. Ultimately,
the user's own application will expect to receive these notifications.
REDIRECT 0xdf 0x3d
REDIRECT 0xef 0x3d
Include FORK_PROCESS commands for all modules that run on the host
computer.
All systems require ssds, tim, and tick modules to be run.
®
For Windows , these FORK_PROCESS commands are mandatory:
FORK_PROCESS ssds.exe
FORK_PROCESS tim_nt.exe
FORK_PROCESS tick_nt.exe
For Linux, these FORK_PROCESS commands are mandatory:
FORK_PROCESS ssds
FORK_PROCESS tim_lnx
FORK_PROCESS tick_lnx
For Solaris, these FORK_PROCESS commands are mandatory:
FORK_PROCESS ssds
FORK_PROCESS tim_sol
FORK_PROCESS tick_sol
Finally, include FORK_PROCESS commands for any modules chosen to run on
the host (e.g., protocol modules, user's application or diagnostic utilities). For
example:
FORK_PROCESS s7_mgt
FORK_PROCESS upe
FORK_PROCESS s7_log
®
DSI SPCI Network Interface Boards Programmer's Manual Issue 5
* s7_mgt - Management/config task
* upe - Example user part task
* s7_log - Prints messages to screen/file
* MTP2 module
* CT bus/Clocking control module
* On-board management module
* ISUP module
* TUP module
* MTP3 module
* LIU/MTP2 status messages -> s7_log
* Other indications -> s7_log
23