Liu Ct Bus Initialization Request - Dialogic DSI SPCI Network Interface Boards Programmer's Manual

6 Message Reference
Parameter Description:
state
The current state of the LIU from the following table:
Status Response
The confirmation message (if requested) indicates success by status of zero.
On error, the following status values can be found in the confirmation
message.
Value
0x01
0xff
6.3.6

LIU CT bus Initialization Request

Synopsis:
This message is sent to the board at initialization time to set up a static
switch path through the board between the Line Interface Unit (LIU) and the
CT bus. It connects selected incoming voice timeslots from a T1/E1 LIU to a
sequential block of channels on the CT bus and prepares the outgoing
timeslots for subsequent use by the MVD_MSG_SC_LISTEN message.
Note: When using s7_mgt, this message is generated by s7_mgt as a result of the
LIU_SC_DRIVE command. It therefore does not need be generated by the user.
62
State
0 OK
1 PCM Loss
2 AIS
3 Sync Loss
4 Remote Alarm
Mnemonic
None
None
Description
Description
Invalid framer ID.
Invalid message length.