6.3.10 Ct Bus Connect Request - Dialogic DSI SPCI Network Interface Boards Programmer's Manual

®
Dialogic DSI SPCI Network Interface Boards Programmer's Manual Issue 5
Description:
This message is sent to the DSI SPCI Board to reset the state of the digital
cross connect switch in accordance with the configuration set using the DSI
SPCI Board configuration message. All CT bus streams are tri-stated leaving
just switch paths established using the board configuration message (i.e.,
signaling timeslots) in place.
The confirmation message (if requested) indicates success by status of zero.
On receipt of the confirmation message the operation to reset the switch has
completed.
Status Response
The confirmation message (if requested) indicates success by status of zero.
No error status values are defined.

6.3.10 CT bus Connect Request

Synopsis:
Message sent to the DSI SPCI Board to control the switch path through the
CT bus switch.
Note: This message provides an alternative approach for controlling switching through
the CT bus switch allowing connections to the CT bus to be utilized only as
required (rather than being set up at initialization time).
69