Table of Contents
Advertisement
C H A P T E R
4 :
G E T T I N G
F R A M E W O R K
Note:
Depending on which algorithms are actually installed the dialog
may look a bit different than Figure 4.25 The order of the
algorithms may be different as well.
Now highlight the radio button
the mouse. Now use the "Scope" measurement algorithm will be demonstrated.
Figure 4.25: Selection of Algorithm Parameters
After selecting the algorithm ´modify some of the parameters used, by the
algorithm by clicking on Properties. This will bring up another dialog, allowing
enterance of some algorithm specific parameters. These parameters will be
explained in detail in the chapters describing each algorithm. For our example
there are no properties to configure.
Remember:
It is always a good idea
since the system starts with the parameters it used for the last measurement.
Now press OK after selecting an algorithm to accept the choice or Cancel to
leave the settings as they were initially. If changing the algorithm or any of its
parameters, a dialog similar to Figure 4.26 will appear, asking for
confirmation of the changes.
T O
K N O W
T H E
O P E R A ™
next to the algorithm , by clicking on it with
to check whether the settings are correct,
59
Properties
Advertisement
Table of Contents
