OPTICOM OPERA - V 3.5 User Manual page 33

C H A P T E R 3 : I N S T A L L A T I O N
Note:
All equipment is designed to work on 220V as well as on 110V
AC.
Installation and Setup
The OPERA system comes completely pre-configured, so no additional setup
procedure is required to run the system. Please refer to the Windows NT
documentation and consult your local network administrator, if attachment of
the system to a network or shared net work printer is desired.
Note:
Please do not upgrade the operating system or the service pack
without consulting OPTICOM.
To setup the OPERA™ portable system, place the main unit on a solid and dry
surface. Attach the dongle to the parallel interface port of the computer, if it is
not yet there, connect the power cable to the side panel of the main unit and
switch on the system. For details, please refer to the hardware documentation
manual.
As default, the OPERA™ system gets his IP address from a DHCP server. If the
OPERA™ system is used without a DHCP server or without a connection to a
network, a fixed IP address must be entered. For instance, enter the IP address
"192.168.0.1". The corresponding netmask in this case is 255.255.0.0. In case
of any doubt, please consult your network administrator.
Note:
Please do never delete the TCP/IP protocol! It is required for
proper operation of the system
For the setup of the audio interface board or the telephony board, please refer to
the corresponding section in Chapter 5 or Chapter 6, respectively.
A N D S E T U P
27
IP Concerns