Table of Contents
Advertisement
C H A P T E R
4 :
G E T T I N G
F R A M E W O R K
Figure 4.20:
OptiCall™ Expert View
While in the Telephony Standard View, the termination side was always
sending the speech file. The Expert View allows for both sides independently
the selection if a speech file shall be sent and/or received.. You can select this
with a check mark besides
With the
Call Options
•
How many consecutive interfaces are to issue a call
•
How often each call shall be repeated (
If
Bulk Call
is selected and 10 entered for
will be issued from the interface selected under
interfaces and the calls will be terminated on the interfaces selected under
Termination
plus the next 9 consecutive interfaces. To distinguish the recorded
files, -Bulksetxx will be appended to the file name, where xx is replaced by a
number indicating the offset to the first originating interface.
All of the above may be repeated several times by checking
entering the desired number of calls under
will have a –xx appended to their file name, where xx is the index of the
repetition, e.g. xyz-2-line0.wav for the second repetition of a call on line 0.
With the settings under
played and recorded during each individual call, before the call is cleared
again. If
Repeat Recording
shall happen and how many milliseconds delay between the recordings shall
T O
K N O W
Transmit
and
Receive
select
No. of Consec. Lines
Total No. of Calls
Active Call Options,
is checked, enter how often the data acquisition
50
T H E
O P E R A ™
for both interfaces separately.
(Bulk Call
Repetitions
).
, then the calls
Origin
, plus the next 9
Repetitions
. The resulting files
adjust how often the speech file is
) and
and
Advertisement
Table of Contents
