OPTICOM OPERA - V 3.5 User Manual page 31

C H A P T E R 3 : I N S T A L L A T I O N
•
Keyboard.
•
Mouse.
•
Two power cords (one power cord included in the case of
international shipments).
•
One or two audio multi cord connectors with cables
(Systems equipped with audio boards only).
•
Two phone splitter cables with three RJ-14 connectors each
(OPR-101-xxx-W telecommunication version only).
•
One dongle / hardware key (may be attached to the printer port
already).
•
One PEAQ Sample CD (systems with installed PEAQ algorithm
only).
•
This manual.
•
Windows NT CD-ROM and manual.
•
Additional documentation and/or software may be included,
depending on the version of the system.
Note:
All equipment is designed to work on 220V as well as on 110V
AC. Please check for any transportation damages.
Installation and Setup
The OPERA™ system comes completely pre-configured, so no additional setup
procedure is required to run the system. Please refer to the Windows NT
documentation and consult your local network administrator, when attachment
of the system to a network or shared network printer is desired.
Note:
Please do not upgrade the operating system or the service pack
without consulting OPTICOM.
To setup the OPERA™ workstation system, place the main unit on a solid and
dry surface. Connect the monitor, mouse, keyboard and the power cables to the
back of the main unit. Attach the dongle to the parallel interface port of the
computer if it is not yet there. Switch on the monitor and the system. For details,
please refer to the hardware documentation manual.
A N D S E T U P
25