Diagnostic Steps; Start Diagnosis Flowchart - HP 155606-001 - ProLiant - ML570R01 User Manual

•
If a fixed cable tray is available for the server, be sure the cords and cables connected to the server
are correctly routed through the tray.
•
Be sure each device is properly seated.
•
If a device has latches, be sure they are completely closed and locked.
•
Check any interlock or interconnect LEDs that may indicate a component is not connected properly.
•
If problems continue to occur, remove and reinstall each device, checking the connectors and sockets
for bent pins or other damage.

Diagnostic steps

To effectively troubleshoot a problem, HP recommends that you start with the first flowchart in this section,
"Start diagnosis flowchart (on page 98)," and follow the appropriate diagnostic path. If the other
flowcharts do not provide a troubleshooting solution, follow the diagnostic steps in "General diagnosis
flowchart (on page 99)." The General diagnosis flowchart is a generic troubleshooting process to be used
when the problem is not server-specific or is not easily categorized into the other flowcharts.
The available flowcharts include:
•
Start diagnosis flowchart (on page 98)
•
General diagnosis flowchart (on page 99)
•
Power-on problems flowchart
•
POST problems flowchart (on page 104)
•
OS boot problems flowchart (on page 105)
•
Server fault indications flowchart (on page 107)
The number contained in parentheses in the flowchart boxes corresponds to a table with references to
other detailed documents or troubleshooting instructions.

Start diagnosis flowchart

Use the following flowchart to start the diagnostic process.
Item Refer to
1 "General diagnosis flowchart (on page 99)"
2 "Power-on problems flowchart
page 101)"
3 "POST problems flowchart (on page 104)"
4 "OS boot problems flowchart (on page 105)"
5 "Server fault indications flowchart (on page 107)"
("Server power-on problems
("Server power-on problems
flowchart" on page 101)
flowchart" on
Troubleshooting 98