Installing the casters
Using a T-15 Torx screwdriver, install the three T-15 Torx screws into each of the four casters.
1.
Attaching the tower bezel
Set the server in its upright tower position.
1.
CAUTION: Be sure to lock the casters and have the access panel in place before turning or reorienting the
server position.
Install the two retention clips to the front of the server chassis.
2.
Line up the hinges on the tower bezel and slide the hinges into the corresponding slots.
3.
Close the front bezel.
4.
Reinstall the power supply, if applicable
5.
Reinstall the hard drives, if applicable.
6.
Plug in all cables
7.
("Redundant hot-plug power
("Rear panel
components" on page 10).
supply" on page 49).
Hardware options installation 77