Remove the power supply blank in the secondary hot-plug power supply bay.
1.
Install the second hot-plug power supply.
2.
Connect the power cord to the redundant power supply.
3.
Secure the power cords to the retaining clip
4.
Connect the power cord to the power source.
5.
Be sure that the power supply LED is green.
6.
Be sure that the front panel external health LED is green
7.
IMPORTANT: For maximum server availability, be sure that the two power supplies are powered by
separate AC power sources.
To replace the component, reverse the removal procedure.
NOTE: If the server will be shipped to another location after configuration, install a shipping screw into
each power supply.
("Setting up a tower
server" on page 37).
("Front panel LEDs and
buttons" on page 9).
Hardware options installation 50