Remove all remaining external cables from the rear panel of the server, including any cables
3.
extending from external connectors on expansion boards.
Remove all hot-plug power supplies
4.
Remove all hot-plug SCSI hard drives.
5.
Remove the tower bezel
6.
the tower
Removing the casters
WARNING: The server is very heavy, up to 63.5 kg (140 lb). To reduce the risk of
personal injury or damage to the equipment:
•
Remove all power supplies and hard drives to reduce the weight of the server before
lifting it.
•
Observe local occupational health and safety requirements and guidelines for manual
material handling.
•
Use more than one person to lift and stabilize the server.
CAUTION: Be sure to lock the casters and have the access panel in place before turning or reorienting the
server position.
To remove the casters:
Place the server on a flat, level surface with the access panel down.
1.
Unscrew the three T-15 Torx screws from each of the four casters and remove the casters.
2.
Removing the tower cover
Loosen and remove the two (2) T-15 Torx screws located on the back of the chassis that attach the
1.
tower cover to the server.
("Removing the tape drive
bezel" on page 29).
("Redundant hot-plug power
blank" on page 55,
supply" on page 49).
"Unlocking and removing
Hardware options installation 72