Server Operations; Power Up The Server; Power Down The Server; Extending The Server From The Rack - HP 155606-001 - ProLiant - ML570R01 User Manual

Server operations

In this section

Power up the server ................................................................................................................................ 27

Power down the server............................................................................................................................ 27

Extending the server from the rack............................................................................................................ 27

Unlocking and removing the tower bezel .................................................................................................. 29
Removing the rack bezel ......................................................................................................................... 30
Access panel ......................................................................................................................................... 31
Power up the server
To power up the server, press the Power On/Standby button.
Power down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
Shut down the OS as directed by the OS documentation.
1.
Press the Power On/Standby button to place the server in standby mode. When the server enters
2.
standby power mode, the system power LED changes to amber.
Disconnect the power cords.
3.
The system is now without power.
Extending the server from the rack
Release the two levers on the lower outside corners of the rack.
1.
NOTE: If the server is in a rack and in the shipping configuration, remove the two shipping screws directly
behind the levers.
IMPORTANT: If the server is installed in a telco rack, remove the server from the rack to access internal
components.
Server operations 27