Item
Description
9
DIMM 5 LED
10
DIMM 6 LED
11
Online Spare LED
12
Hot-Plug Mirrored
LED
13
Hot-Plug RAID LED
14
Board Status LED
*The following applies to an invalid AMP error. This error occurs when the current memory configuration is not valid
for the configured AMP mode:
•
If the mode selected is the desired mode, modify the DIMM/board configuration to support the
desired mode. Refer to the memory overview section.
•
If the mode selected is not the desired mode, run RBSU and change the AMP mode. Refer to "HP
ROM-Based Setup Utility
NOTE: If the Online Spare, Mirrored, and RAID LEDs are off, the server is in Advanced ECC mode. Refer to
"HP ROM-Based Setup Utility (on page 87)" for more information.
The following table illustrates the different LED combinations for a correctly configured memory board.
LED
Advanced ECC
Memory
Board status
Green
Status
Green = DIMM installed
Amber = Failed or degraded DIMM
Flashing amber = DIMM configuration error
Off = No DIMM installed
Green = DIMM installed
Amber = Failed or degraded DIMM
Flashing amber = DIMM configuration error
Off = No DIMM installed
Green = Online spare mode
Amber = Degraded online spare mode
Flashing amber = Invalid AMP mode*
Off = Not in Online Spare mode
Green = Mirrored mode
Amber = Degraded mirrored mode
Flashing amber = Invalid AMP mode*
Off = Not in Mirrored mode
Green = RAID mode
Amber = Degraded RAID mode
Flashing amber = Invalid AMP mode*
Off = Not in RAID mode
Off = Power off - memory board locking switch not
engaged or invalid memory configuration.
Green = Normal operation
Flashing green = Board is rebuilding
Flashing amber = DIMM on this board encountered
memory errors
Amber Flashing = one of the following conditions:
•
Unlocking a memory board that should not be
removed
•
Attempting to insert a memory board at runtime
that fails
("HP ROM-Based Setup
Online Spare
Hot-Plug
Memory
Mirrored
Memory
Green
Green
Utility" on page 87)" for more information.
Hot-Plug RAID
Memory
Green
Server component identification 22