Scratch/Skid; Filter/Phase; Echo/Flanger/Robot - American Audio VELOCITY MP3 User Manual And Reference Manual

BUILT-IN EFFECTS
Figure 52
FILTER/PHASE EFFECT:
the original sound to add different tonal definition. When the Filter
Effect is activated the FILTER/PHASE BUTTON (7) will glow yellow,
when the Phase Effect is selected the button will glow red. The
reaction these effects have to the original tonal definition can be
altered by changing the PARAMETER TIME (13) and PARAMETER
RATIO (14).
Figure 54
FLANGER EFFECT:
phasing in and out of each other. The FLANGER Effect has two adjustable parameters, Parameter Time (PT)
and Parameter Ratio (PR). The PT will adjust the Flanger Mode and The PR will adjust the Flanger Frequency
Range (see "Parameters" in the next section).
ECHO EFFECT:
The ECHO effect adds an echo to your output signal. The ECHO Effect has two adjustable
parameters, Parameter Time (PT) and Parameter Ratio (PR). The PR will adjust the length of the echo (drop off
time), and the PT will adjust the echo gap length (see "Parameters" in the next section).
off time), and the PT will adjust the echo gap length.
©
The Filter and Phase effects tweak
The flanger effect alters the output signal and creates an effect similar to frequencies
American Audio - www.AmericanAudio.us - Velocity Mp3™ Instruction Manual Page 32
®
SCRATCH/SKID EFFECT:
time turntable scratching. The Skid effect simulates the sudden
platter stop of a turntable, like pressing the stop button on a turn-
table. When the Scratch Effect is activated the SCRATCH/SKID
BUTTON (18) will glow red, when the Skid Effect is selected the
button will glow yellow. Once the Scratch Effect has been acti-
vated the JOG WHEEL (24) may be used in the same fashion a
turntable platter is used. Use the JOG WHEEL (24) to simulate
the scratch motion on a turntable platter and to manipulate play-
back. Both the Skid and Scratch TIME PARAMETERS (13) can be
adjusted from 0010 to 9990. 9990 will give you the longest Skid
times. The SKID value ranges from a 10ms to ten seconds.
Figure 53
FLANGER/ECHO/ROBOT EFFECT:
the output signal and create an effect similar to the frequencies
phasing in and out of each other. The echo effect adds an echo
to your output signal. The robot effect alters the output to simu-
lates a sci-fi robot voice. When the flanger effect is selected the
FLANGER/ECHO BUTTON (8) will glow yellow, when the echo
or robot effect is selected the FLANGER/ECHO BUTTON (8) will
glow red.
ROBOT EFFECT:
simulates a sci-fi robot voice. The ROBOT effect is activated in
the echo parameters (see "Parameters" in the next section). To
activate the robot effect select the echo effect (FLANGER/ECHO
BUTTON (8) will glow yellow). After the Echo effect is activated
turn the HOLD (19) function on. Use the PARAMETER TIME
KNOB (13) and set the (PT) value to 0010. After "PT" value has
been set, use the PARAMETER RATIO KNOB (14) to create the
effect by turning it back and forth.
The Scratch Effect simulates real
The flanger effect alters
The ROBOT effect alters the output to