Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for American Audio DCD-PRO300 MKII
Summary of Contents for American Audio DCD-PRO300 MKII
- Page 1 DCD-PRO300 MKII © American AUDIO Los Angeles, CA 90058 USA...
- Page 2 (ser- vicing) instructions in the user manual accompanying the CD player. American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 2 NOTE: This CD player uses a semiconductor laser. It is recommended for use in a room at the following temperature: 41˚F - 95˚F / 5˚C - 35˚C...
-
Page 3: Safety Instructions
9. Grounding or Polarization - Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 3 10. Power-Cord Protection - Power-supply cords should be routed so that they are not likely... - Page 4 Be sure to use the supplied control cables. Using another type of cable may result in damage. Be sure the power is off when connecting the control cables. Otherwise the units may not work properly. American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 4 • The control panel's LCDs are designed to be clearly visible within the angles shown in Figure 2.
-
Page 5: General Notes On Use
(13) Large brite LCD Screen can be viewed from wide angles. (14) Transport protection *Must have a Mixer equipped with the signal output. Look for this feature in Future American DJ Mixers. (15) Mechanical Anti-Skip American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 5... -
Page 6: General Features
NOTE: Tray will not open unless the disc has been paused. American audio • DCD-PRO400™ INSTRUCTIONS MANUAL • PAGE 6 LCD DISPLAY - Indicates all the functions, as they are occurring, with the CD. These functions are explained in the next section. - Page 7 RELOOP BUTTON - If a LOOP has been made, American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 7 and you have hit the exit button, press this button to enter the loop again. To exit loop press OUT/EXIT button.
-
Page 8: Basic Operations
• The point at which playback starts is automatically stored in the memory as the cue point. The pickup then returns to the cue point (the point at which playback started) when the CUE button is pressed. (Back Cue) American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 8 3 in. / 8cm disk... - Page 9 10. SCANNING (FAST FORWARD / FAST REVERSE) To do this rotate Shuttle wheel forward or reverse. You can scan or reverse in 6 different speeds depending on how much you rotate the wheel. American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 9...
-
Page 10: Time Display
(3) Engage Pitch by pressing PITCH on the side you want to use, make sure Readout is in BPM by pressing BPM BUTTON until BPM is lit on LCD . Adjust pitch until same BPM as original song is reached. American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 10... -
Page 11: Before Switching Off The Power
If a CD is left in the player and the remote has been disconnected, plug power cable in, turn on power and take out CD. American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 11 Fig. 15 Switch off the power after the disc holder has been closed with the OPEN/CLOSE button. -
Page 12: Specifications
Fax: 323-582-2610 Web: www.americanaudio.us E-mail: info@americandj.com American audio • DCD-PRO300™ INSTRUCTIONS MANUAL • PAGE 12 19"(W) x 3 15/32” (H) x 9 55/64” (D) 482mm (W) x 88.8mm (H) x 264mm (D) (without feet) 19"(W) x 5 3/4” (H) x 1 1/2” (D)
Need help?
Do you have a question about the DCD-PRO300 MKII and is the answer not in the manual?
Questions and answers