American Audio VELOCITY MP3 User Manual And Reference Manual page 23

BASIC OPERATIONS (CONT.)
Changing the Sample Parameters:
Changing the sample parameters allows you to change the sample's volume (SV) and pitch (SP). The
parameter values for the pitch range from -9:99 to +10:00 (-9:99 being the lowest) and volume values
range from 00:00 to 10:00 (00:00 being the lowest). A higher value will increase the pitch percentage
or volume. It's important to understand that the pitch value is basically a speed adjustment and has
nothing to do with tonal quality. The values can be either a momentary change or set adjustment.
While in sample playback mode, make sure the FOLDER/TRACK BUTTON (15) is turned "off", mean-
ing the button LED is not lit, then:
Changing the Sample Parameters - Speed
While a sample is playing push the PARAMETERS TIME KNOB
(13). One tap will display
will signify the pitch percentage (speed) of the sample. +0 00 is
your default setting - Normal playback. Any adjustments will be
based on this default setting. Turning the knob in a clockwise
direction will increase your pitch. Turning the wheel in a counter-
clockwise direction will decrease the parameters value.
Changing the Sample Parameters - Hold Function
Hold Function - This function will allow you to save and lock your
parameter adjustments, if the hold function is not activated all your
parameter adjustments will be momentary. If you use the HOLD
BUTTON (19) all parameters will remain in the unit's memory until
they are changed again or main power is shut off, unless they are
stored in to the unit's memory (see page 26 System Memory).
©
SP +0 00
in the VFD DISPLAY (17).
Figure 27
American Audio - www.AmericanAudio.us - Velocity Mp3™ Instruction Manual Page 23
®
SP
Figure 26
Changing the Sample Parameters - Volume
While a sample is playing push the PARAMETERS RATIO KNOB
(14). One tap will display
will signify the volume of the sample. 10 00 is your default setting
- Normal playback. Any adjustments will be based on this default
setting. Turning the knob in a clockwise direction will increase
the volume. Turning the wheel in a counter-clockwise direction
will decrease the parameters value.
SV 10 00
in the VFD DISPLAY (17).
Figure 28
SV