Show Interface - Cisco CSACS-1121-K9 Reference Manual

Show Commands
Example 2
acs/admin# show icmp_status
icmp echo response is turned off
acs/admin#
Related Commands Command
icmp echo

show interface

To display the usability status of interfaces configured for IP, use the show interface command in the
EXEC mode.
Syntax Description GigabitEthernet
|
Defaults
No default behavior or values.
Command Modes
EXEC
Usage Guidelines None.
Examples
acs/admin# show interface
eth0
CLI Reference Guide for the Cisco Secure Access Control System 5.1
A-74
show interface [GigabitEthernet] |
Shows the Gigabit Ethernet interface. Either 0 or 1.
Output modifier variables:
begin—Matched pattern. Up to 80 alphanumeric characters.
•
count—Count the number of lines in the interface. Add number after the
•
word count.
end—End with line that matches. Up to 80 alphanumeric characters.
•
exclude—Exclude lines that match. Up to 80 alphanumeric characters.
•
include—Include lines that match. Up to 80 alphanumeric characters.
•
last—Display last few lines of output. Add number after the word last.
•
Up to 80 lines to display. Default 10.
Link encap:Ethernet
inet addr:209.165.200.225 Bcast:209.165.200.255 Mask:255.255.255.224
inet6 addr: fe80::216:36ff:fe56:61d2/64 Scope:Link
UP BROADCAST RUNNING MULTICAST
RX packets:8783423 errors:0 dropped:0 overruns:0 frame:0
TX packets:4178157 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
Description
Configures the Internet Control Message Protocol (ICMP) echo
requests.
HWaddr 00:16:36:56:61:D2
MTU:1500
Appendix A ACS Command Reference
Metric:1
OL-18996-01