Using The Acs Command Line Interface; Before Accessing The Acs Cli; Starting The Csacs-1121; Running Setup To Configure Acs - Cisco CSACS-1121-K9 Reference Manual

Before Accessing the ACS CLI

Starting the CSACS-1121

Complete these steps before you configure the CSACS-1121 appliance:
Connect the power cord to the CSACS-1121 (see
Step 1
Figure 2-1
.
1
2
3
Connect the network cable to the Gigabit Ethernet 0 connector (see
Step 2
appears when the CSACS-1121 boots) only configures the Gigabit Ethernet 0 port. For information on
connecting cables, see the Installation and Upgrade Guide for the Cisco Secure Access Control
System 5.1.
Power up the CSACS-1121. The appliance boots automatically and the setup utility appears (see
Step 3
Running Setup to Configure ACS, page

Running Setup to Configure ACS

When you power up the CSACS-1121 appliance for the first time, you are prompted to run the setup
utility to configure the appliance. Before you run the utility using the setup command, ensure that you
have values for the following network configuration prompts:
•
•
•
•
•
•
•
•
CLI Reference Guide for the Cisco Secure Access Control System 5.1
2-2
Rear View of CSACS-1121
1
AC power receptacle
Serial connector
Video connector
Hostname
IP address
Netmask
Gateway
Domain
Nameserver
User ID
Password
Chapter 2
Figure 2-1).
6 4
5
4 Gigabit Ethernet 0
5
USB 3 connector
6
USB 4 connector
2-2).

Using the ACS Command Line Interface

3 2
Figure 2-1). The setup utility (that
OL-18996-01