Interface; Icmp Echo - Cisco CSACS-1121-K9 Reference Manual

Appendix A ACS Command Reference
Command Modes Configuration
Usage Guidelines None.
Examples
acs/admin(config)# icmp echo off
acs/admin(config)#
Related Commands Command
show icmp-status

interface

To configure an interface type and enter the interface configuration mode, use the interface command
in Configuration mode. This command does not have a no form.
Syntax Description
GigabitEthernet
0 | 1
After you enter the Gigabit Ethernet port number in the interface command, you enter the
Note
config-GigabitEthernet configuration submode (see the following Syntax Description).
do
end
exit
ip
no
shutdown
Defaults No default behavior or values.
OL-18996-01
interface GigabitEthernet [0 | 1]
Configures the Gigabit Ethernet interface.
Number of the Gigabit Ethernet port to configure.
EXEC command. Allows you to perform any EXEC commands in this mode
(see
Exits the config-GigabitEthernet submode and returns you to the EXEC
mode.
Exits the config-GigabitEthernet configuration submode.
Sets the IP address and netmask for the Ethernet interface (see
page
Negates the command in this mode. Two keywords available:
•
•
Shuts down the interface (see
Description
Display ICMP echo response configuration information.
do, page A-118).
A-124).
ip—Sets the IP address and netmask for the interface.
shutdown—Shuts down the interface.
shutdown, page
CLI Reference Guide for the Cisco Secure Access Control System 5.1
Configuration Commands
ip address,
A-137).
A-123