Kron Occurrence; Ip Route - Cisco CSACS-1121-K9 Reference Manual

Configuration Commands
Command Modes Configuration.
Examples
acs/admin(config)# ip route 192.168.0.0 255.255.0.0 gateway 172.23.90.2

kron occurrence

To schedule one or more Command Scheduler commands to run at a specific date and time or a recurring
level, use the kron occurrence command in Configuration mode. To delete this, use the no form of this
command.
Syntax Description
occurrence
occurrence-name
After you enter the occurrence-name in the kron occurrence command, you enter the config-occurrence
Note
configuration submode (see the following Syntax Description).
at
do
end
exit
no
policy-list
recurring
Defaults No default behavior or values.
CLI Reference Guide for the Cisco Secure Access Control System 5.1
A-128
kron {occurrence} occurrence-name
Schedules Command Scheduler commands.
Name of the occurrence. Up to 80 alphanumeric characters. (See following
note and Syntax Description.)
Identifies that the occurrence is to run at a specified calendar date and time.
Usage: at [hh:mm] [day-of-week | day-of-month | month day-of-month].
EXEC command. Allows you to perform any EXEC commands in this mode
(see
Exits the kron-occurrence configuration submode and returns you to the
EXEC mode.
Exits the kron-occurrence configuration mode.
Negates the command in this mode.
Three keywords available:
•
•
•
Specifies a Command Scheduler policy list to be run by the occurrence.
Identifies that the occurrences run on a recurring basis.
do, page A-118).
at—Usage: at [hh:mm] [day-of-week | day-of-month | month
day-of-month].
policy-list—Specifies a policy list to be run by the occurrence. Up to 80
alphanumeric characters.
recurring—Execution of the policy lists should be repeated.
Appendix A ACS Command Reference
OL-18996-01