Ac Input Wiring To The Main Utility Breaker Box; Installation (Continued); Figure 3-13 Utility Breaker Box Wiring Diagram - Xantrex7 UX - REV A Owner's Manual

3.0 Installation
AC Wiring (continued)

AC Input Wiring to the Main Utility Breaker Box

WARNING: MAKE CERTAIN
THE POWER TO THE MAIN
UTILITY BREAKER BOX IS
DISCONNECTED! NEVER
WORK ON LIVE CIRCUITS.
CAUTION: Inspect all wiring
for proper installation
before reinstalling the
cover plate.
NOTE: For illustrative purposes
only. Breaker boxes vary
depending on the
application. Main panel
wiring to non-critical loads
is not illustrated.
44
1. Remove the cover plate from the main utility breaker box.
2. Connect the ground (green) wire to the GROUND bus in the main utility
breaker box.
3. Connect the neutral (white) wire to the NEUTRAL bus.
4. Connect the hot (black) wire to the circuit breaker that was installed for the
inverter.
5. Torque all wires to the manufacturer's specifications.
Figure 3-13
Utility Breaker Box Wiring Diagram
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0026-01-01 Rev A 06/2002