3.0 Installation
DC Wiring (continued)
Installing the Battery Temperature Sensor (BTS)
NOTE: This accessory requires the
installation of the SB
Option on the inverter.
Battery
Temperature
Sensor (BTS)
(RJ11) Port
RJ11 Connector
Sensor
38
1.
Insert the RJ11 connector on the battery temperature sensor wire into the BTS
port located on the AC end of the inverter.
2.
Secure the sensor to one of the batteries located in the center of the battery
pack.
Figure 3-8
BTS (RJ11) Port Location
Figure 3-9
BTS Installed on Battery
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0026-01-01 Rev A 06/2002