Xantrex7 UX - REV A Owner's Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
NOTE: This statement is important.
Follow instructions closely.
NOTE: Cette déclaration est
importante. Suivre les
instructions de près.
CAUTION - This procedure is
critical to the safe installation
or operation of the unit.
Follow these instructions
closely.
ATTENTION - Cette procédure
est essentielle à l'installation
ou l'utilisation de l'unité en
toute sécurité. Suivre ces
instructions de près.
WARNING - A
DANGEROUS VOLTAGE OR
CONDITION EXISTS IN THIS
AREA. USE EXTREME
CAUTION WHEN
PERFORMING THESE
TASKS.
AVERTISSEMENT - UNE
TENSION OU CONDITION
DANGEREUSE EXISTE
DANS CETTE ZONE. FAIRE
PREUVE D'EXTRÊME
PRUDENCE LORS DE LA
RÉALISATION DE CES
TÂCHES.
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0026-01-01 Rev A 06/2002
This manual contains important safety instructions that should be followed
during the installation and maintenance of this product.
To reduce the risk of electrical shock, and to ensure the safe installation and
operation of this product, the safety symbols shown on this page have been
placed throughout this manual to indicate dangerous conditions and important
safety instructions.
• All electrical work must be done in accordance with local, national, and/or
international electrical codes.
• Before installing or using this device, read all instructions and cautionary
markings located in the manual, and in (or on) the inverter, the batteries, and
the PV array.
• Do not expose this unit to rain, snow, or liquids of any type. This product is
designed for indoor mounting only.
• To reduce the chance of short circuits, use insulated tools when installing or
working with the inverter, the batteries, or the PV array .
• Remove ALL jewelry while installing this system. This will greatly reduce the
chance of accidental exposure to live circuits.
• The inverter contains more than one live circuit (AC line, batteries and/or PV
array). Power may be present at more than one source.
• This product does not contain any user-serviceable parts. Do not attempt to
repair this unit. All repairs should be done by an Authorized Service Center.
• DO NOT install 120 volt AC stand-alone inverters onto 120/240 volt AC multi-
branch circuit wiring. This could pose a fire hazard due to an overloaded neutral
return wire in this configuration.
See Section 5.0, Troubleshooting, pages 59 - 63, for additional information on
multi-branch circuit wiring.
SAVE THESE INSTRUCTIONS
iii