Inverter Mounting; Figure 3-4 - Wall-Mounting Method - Xantrex7 UX - REV A Owner's Manual

3.0 Installation

Inverter Mounting

WARNING: USE
APPROPRIATE LIFTING
TECHNIQUES. HAVE
EXTRA PEOPLE ON HAND
TO ASSIST IN LIFTING
THE INVERTER INTO
POSITION WHILE IT IS
BEING SECURED.
Ceiling
9 5/8"
center to center
Approximately
4 ft
32
The UX inverter is designed for either shelf-mounting or wall-mounting.
The UX inverter can weigh as much as 40 pounds (18.2 kg). Wallboard is not
strong enough to support this much weight so additional support must be added.
The easiest method for securing the inverter to an existing wall is to place two
2 x 4's horizontally on the wall (spanning at least three studs) and securing the
inverter to the 2 x 4's.
Wall studs 16 inches
on center
Drill holes for
mounting here
12 1/32"
(center to center)
Drill holes for
mounting here
12 1/32"
(center to center)
Figure 3-4
Wall-mounting Method (Not-to-Scale)
2 x 4 mounting
supports
Wallboard
Floor
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0026-01-01 Rev A 06/2002