Electrical Connection - Dacor Epicure ER30D Installation Instructions Manual

Removing the Oven Door
• Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
• Do not lift or carry the oven door by the handle.
To make the range easier to move, remove the door to reduce
weight.
1. Open the door to its fully opened position.
2. Rotate the catch over the retaining arm on each hinge.
Catch
Retaining arm
3. Lift the oven door to about a 15° angle from the vertical
position.
4. Hold the door with both hands just below the handle and pull
it away from the oven while continuing to lift.
Door Gripping Points
12
Installation Instructions
WARNING

Electrical Connection

• Wire the range only in compliance with local ordinances.
• Do not turn on power to the range until instructed to do
so in the Verifying Proper Operation section of these
instructions.
• Improper connection of the electrical wiring can cause an
electric shock hazard and damage the appliance. Dacor
is not responsible for damages resulting from improper
installation.
• The ground terminal (or lead) on the appliance must be
connected to a grounded, metallic, permanent wiring
system or grounding conductor.
• Do not use an extension cord with this appliance. Such use
may result in fire, electric shock or other personal injury.
• Do not install a fuse in the neutral or ground circuit. A fuse
in the neutral or ground circuit may result in an electric
shock hazard.
NOTE: Freestanding model ER30D-C is wired for use in Canada
and comes from the factory pre-wired. If installing a pre-wired
range, skip to Gas Supply Connection on page 17.
IMPORTANT:
• Make sure that the conduit or appliance cord is long enough
to allow the range to be pulled out for service without
disconnecting it from power.
• Do not disconnect any of the wires inside the range electrical
box unless instructed to do so.
Electrical access cover
WARNING
Put slack in
electrical wiring
and gas line
Back of range