Dacor Epicure ER30D Installation Instructions Manual page 12

ARSP3 Side Panel Kit Installation (cont.)
2. Close the door. Remove and retain the two screws from the
back of the kick panel as shown below. Pull the kick panel
free from the front of the unit.
Kick panel
3. Remove the left end cap retaining screw from under the rim
of the control panel and remove the end cap.
End cap
4. Hold the left side panel in position on the side of the range.
Locate the center mounting hole. Remove and retain the
screw attached to the chassis beneath it.
Side panel
Center mounting
hole
Left side only:
Remove and
reuse this screw.
10
Installation Instructions
Remove and
retain screw,
both sides
5. Insert the tabs on the trim piece into the slots on the range.
6. Use the hex head screw (83023) removed from the side, a
Torx head screw removed from the kick panel and the hex
screws from the kit to attach the side panel to the range.
Three (3) hex head screws attach the side. One (1) Torx head
screw (83709) inserts through the end cap hole to attach
the top of the side panel. One (1) Torx head screw (83709)
inserts through a hole in the front panel to attach the bottom
of the side panel.
Hex screw
Side panel
Hex screw
Hex screw
7. Reinstall the end cap.
8. Repeat steps 3 to 7 for the right side panel.
an additional hex screw (83023) in the kit for the right side
panel because the center mounting screw is not reused as
with the left side (do not perform step 4).
Torx screw
Torx screw
Front panel
NOTE: There is