Dacor Epicure ER30D Installation Instructions Manual page 13

9. With the door closed, reattach the kick panel to the range
by snapping the ball studs on the back of the panel into the
holes on the front panel of the range.
10. Open the door and reattach the kick panel top screws
removed in step 1.
Space between
door and oven
opening
Installing a Raised Vent (Optional)
Install the ERV30 or PRV30 raised vent before final installation
of the range. See the raised vent installation instructions, part no.
65335.
IMPORTANT: The ERV30 or PRV30 raised vent attaches to the
narrow back portion of the raised vent/range cutout. It is self-
supporting in the cutout and does not actually attach to the range
itself.
Installation Instructions
Reattach kick panel
with existing screws
Level and Adjust the Range Height
Raise or lower the range to prepare for final installation:
• For model ER30D and ER30D-C, adjust the height until the
top edge of the trim around the edge of the of the cooktop is
slightly higher than the countertop.
• For model ER30DSR, raise the range until the bottom edge
of the trim around the edge of the of the cooktop is 1/8"
higher than the countertop.
Rear leg
up
down
Install the Anti-Tip Bracket and Foot
1. Locate the anti-tip foot and lower it until it is 1/16" (2 mm) off
the floor.
2. Locate the anti-tip bracket included in the parts box.
Bracket
Back of
range
3. Install the anti-tip bracket on the floor using the four (4)
included screws. See the diagram above for location.
ANTI-TIP BRACKET PLACEMENT
A
B
Back of range
2 1/8" *
* Distance to floor:
2 7/16" to 4 9/16"
Back of
range
Anti-tip
foot
Top view
A B
Right side
of range
6 5/8" (168 mm)
6 3/8" (162 mm)
11