Dacor Renaissance ER30D Installation Instructions Manual
Hide thumbs
Also See for Renaissance ER30D:
- Technical manual (49 pages) ,
- Use and care manual (36 pages) ,
- Installation instructions manual (24 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dacor Renaissance ER30D
Summary of Contents for Dacor Renaissance ER30D
-
Page 1: Installation Instructions
Installation Instructions Renaissance Range ® For use with models ER30D, ER30D-C, ER30DSR THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. Part No. 102187 Rev. P... -
Page 2: Table Of Contents
Leave these installation instructions with the customer. • Customer: Keep these installation instructions for future reference and the local building inspector’s use. All specifications subject to change without notice. ® Dacor assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved. -
Page 3: Important Safety Instructions
Use common sense and caution when installing, monoxide poisoning and overheating of the appliance. maintaining or operating this or any other appliance. Always contact the Dacor Customer Service Team about problems WARNING and conditions that you do not understand. -
Page 4: General Safety Precautions
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. •... -
Page 5: Customer Service Information
Customer Service Information If you have questions or problems with installation, contact your Model Identification Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty, call the Dacor Distinctive ER30DSR-C-SCH/NG/H Service line. Whenever you call, have the model and serial number of the appliance ready. -
Page 6: Planning The Installation
Planning the Installation Electrical Requirements WARNING Model ER30D-C IMPORTANT: Observe all governing codes and ordinances during planning and installation. Contact your local building • Model ER30ED-C is a freestanding range that comes with department for further information. a factory installed 4-wire appliance cord and NEMA 14-50P Electrical Requirements plug. -
Page 7: Product Dimensions
Planning the Installation Product Dimensions Product tolerances: ±1/16” (±1.6 mm), unless otherwise stated GAS - ELECTRICAL ACCESS DIMENSIONS inlet Range electrical access, 4 7/8” 21 3/4” 8 5/8” 10 3/16” cover removed (12.4 cm) (55.2 cm) (21.9 cm) (25.9 cm) * When using an appliance cord, the hole size must be increased to 1 1/8”... - Page 8 NOTE: Self-rimming models are designed to allow the trim to overlap the countertop when configured to the dimensions on Product tolerances: ±1/16” (±1.6 mm), unless otherwise stated page 8. NOTE: Self-rimming models are not compatible with Dacor integral backguards. 45 5/8” (115.9 cm) Front of open door 28 3/16”...
-
Page 9: Cabinet Layout
• In the freestanding configuration, the range may be installed the range is in place. flush to the rear wall. For all installations, Dacor highly • The gas supply piping, gas shut-off valve and the electrical recommends installing a non-combustible material on the rear... -
Page 10: Installation Instructions
• On installations with a downdraft vent (see above right), install Dacor trim kit ATK30SR. When sliding the range into position, it will stop when the rear of the control panel contacts the notches toward the front of the countertop. The range trim will partially cover the front of the downdraft vent chassis in back. -
Page 11: Removing The Oven Door
Installation Instructions Changing the Backguard (models ER30D Removing the Oven Door and ER30D-C only) WARNING Models ER30D and ER30D-C come standard with a 3” backguard • Do not attempt to disengage the hinge catches with the installed. The 6” backguards is optional. Install according to the door removed from the oven. -
Page 12: Electrical Connection
Improper connection of the electrical wiring can cause an • 3 wire appliance cord (where local codes permit) electric shock hazard and damage the appliance. Dacor The sections below and on the following pages give directions for is not responsible for damages resulting from improper connecting each type of wiring harness. - Page 13 Installation Instructions Bare wire connections Loop and spade terminal connections L1 terminal Neutral terminal L1 terminal Jumper link Neutral terminal L2 terminal Black wire L2 terminal White wire Link removed Grounding screw Red wire Red wire Green wire Conduit strain White wire relief nut Black wire...
- Page 14 Installation Instructions Electrical Connection (cont.) Connecting the Conduit to the House Connection to Electrical Junction Box power supply WARNING • Do not ground the appliance to a gas supply pipe or hot Junction box water pipe. • Do not turn on power to the appliance until the range is permanently grounded.
- Page 15 Installation Instructions Separate No. 10 (minimum) Connection to copper grounding wire power supply Junction box Fasten clamp tightly on pipe Wire nut 4 places Connection to appliance (Page 10) 4 Wire Conduit Connection to Junction Box with External Ground No. 4 Meter copper wire Metal...
- Page 16 Installation Instructions Electrical Connection (cont.) Slide the end of the appliance cord into the strain relief from the bottom of the box. Appliance Cord Connections - Where Connect the white (neutral) wire to the neutral terminal in the box. Local Code Permits Connect the L1 wire to the L1 power supply terminal in the box.
-
Page 17: Gas Connection
Installation Instructions Gas Connection WARNING • Make sure the gas supply valve is off and that the power to Bare wire the range is turned off at the circuit breaker or fuse box prior connections to connecting the gas line. •... -
Page 18: Final Installation
Installation Instructions Final Installation Re-installing the Oven Door Peel the protective plastic coating off of the range, including WARNING the range door. To avoid personal injury or damage to the door from it falling off Measure from the floor to the countertop. its hinges: Adjust the leveling legs: •... -
Page 19: Installing The Burner Knobs
Installation Instructions Installing the Burner Knobs WARNING Installing the range knobs in the wrong position may result in damage to the griddle included with the range. The knobs for the right burners are marked with the maximum griddle settings. There are two (2) different types of knobs supplied with the range. The knobs for the right burners have the words “MAX GRIDDLE”... -
Page 20: Cooktop Assembly
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. Spill tray • Remove the burner rings, burner caps and grates from their shipping packages. Stack burner •... -
Page 21: Verifying Proper Operation
Repeat the above bake test or burner ignition test. If the appliance still does not work, contact Dacor Distinctive Service at (800) 793-0093 ex. 2822. Do not attempt to repair the appliance yourself. Have the model and serial numbers available when you call. - Page 22 Notes...
- Page 24 Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com...
Need help?
Do you have a question about the Renaissance ER30D and is the answer not in the manual?
Questions and answers