Dacor Epicure ER30D Installation Instructions Manual
Installation instructions
Hide thumbs
Also See for Epicure ER30D:
- Technical manual (49 pages) ,
- Use and care manual (36 pages) ,
- Installation instructions manual (24 pages)
Table of Contents
Related Manuals for Dacor Epicure ER30D
Summary of Contents for Dacor Epicure ER30D
-
Page 1: Installation Instructions
Installation Instructions Epicure Range ® For use with models ER30D, ER30D-C, ER30DSR THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES. Part No. 102187 Rev. J... - Page 2 All specifications subject to change without notice. ® Dacor assumes no liability for changes to specifications. © 2007 Dacor, all rights reserved.
-
Page 3: Table Of Contents
Do not touch any electrical switch or use any electrical maintaining or operating this or any other appliance. devices, including the telephone, in your building. Always contact the Dacor Customer Service Team about problems • From a neighbors phone, immediately call the gas supplier. -
Page 4: Important Safety Instructions
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. •... -
Page 5: Customer Service Information
Customer Service Information If you have questions or problems with installation, contact your Model Identification Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty, call the Dacor Distinctive ER30DSR-C-SCH/NG/H Service line. Whenever you call, have the model and serial number of the appliance ready. -
Page 6: Planning The Installation
Refer to the ratings on the range rating label. grounding, must be in accordance with the National Electric Code ER30D/ER30DSR ELECTRICAL SPECIFICATIONS ANSI/NFPA 70-1993* (or latest revision) and local codes and ordinances. A copy of this standard may be obtained from:... -
Page 7: Product Dimensions
35 3/4” (908 mm) Finished side panel 37 7/8” (962 mm) NOTE: Models ER30D and ER30D-C are NOT designed for use with self-rimming installations or raised vents. Use model ER30DSR for self-rimming and raised vent installations. Freestanding Models: ER30D and ER30D-C... - Page 8 NOTE: Self-rimming models are designed to allow the trim to overlap the countertop when configured to the dimensions on Product tolerances: ±1/16” (±1.6 mm), unless otherwise stated page 8. NOTE: Self-rimming models are not compatible with Dacor integral backguards. 45 5/8” (1159 mm) Front of open door 28 3/16”...
-
Page 9: Cabinet Layout
• In the freestanding configuration, the range may be installed the range is in place. flush to the rear wall. For all installations, Dacor highly • The gas supply piping, gas shut-off valve and the electrical recommends installing a non-combustible material on the rear... -
Page 10: Installation Instructions
On installations with a raised vent (see above right), install raised vent (610 mm) (610 mm) 26 1/16” Dacor trim kit ATK30SR. When sliding the range into position, 3-inch side panels 21” 21 1/2” to it will stop when the rear of the control panel contacts the 21”... - Page 11 Installing the ATK30SR Raised Vent Trim Kit and ER30D-C only) (model ER30DSR only) Models ER30D and ER30D-C come standard with a 3” backguard To install the optional raised vent with self-rimming model installed. The 6” and 9” backguards are optional.
- Page 12 Installation Instructions ARSP3 Side Panel Kit Installation (cont.) Insert the tabs on the trim piece into the slots on the range. Use the hex head screw (83023) removed from the side, a Close the door. Remove and retain the two screws from the Torx head screw removed from the kick panel and the hex back of the kick panel as shown below.
- Page 13 Raise or lower the range to prepare for final installation: holes on the front panel of the range. • For model ER30D and ER30D-C, adjust the height until the top edge of the trim around the edge of the of the cooktop is slightly higher than the countertop.
-
Page 14: Electrical Connection
NOTE: Freestanding model ER30D-C is wired for use in Canada and comes from the factory pre-wired. If installing a pre-wired range, skip to Gas Supply Connection on page 17. - Page 15 Installation Instructions Connecting the Wiring to the Range Refer to the range rating label (see page 3) for power requirements. L1 terminal There are four possible ways to wire the range: Neutral terminal • 4 wire conduit • 3 wire conduit (where local codes permit) Jumper link •...
- Page 16 Installation Instructions Electrical Connection (Continued) Connecting the Conduit to the House Connection to Electrical Junction Box power supply WARNING • Do not ground the appliance to a gas supply pipe or hot water pipe. Junction box • Do not turn on power to the appliance until the range is permanently grounded.
- Page 17 Installation Instructions Separate No. 10 (minimum) Connection to copper grounding wire power supply Junction box Fasten clamp tightly on pipe Wire nut 4 places Connection to appliance (Page 13) 4 Wire Conduit Connection to Junction Box with External Ground No. 4 Meter copper wire Metal...
- Page 18 Installation Instructions Electrical Connection (Continued) Slide the end of the appliance cord into the strain relief from the bottom of the box. Appliance Cord Connections - Where Connect the white (neutral) wire to the neutral terminal in the box. Local Code Permits Connect the L1 wire to the L1 power supply terminal in the box.
-
Page 19: Gas Connection
Installation Instructions Gas Connection WARNING • Make sure the gas supply valve is off and that the power to the range is turned off at the circuit breaker or fuse box prior Bare wire to connecting the gas line. connections •... -
Page 20: Final Installation
Installation Instructions Final Installation Installing the Burner Knobs Peel the protective plastic coating off of the range, including CAUTION the range door. Installing the range knobs in the wrong position may result in Carefully slide the range into position in the cutout. The rear damage to the griddle included with the range. -
Page 21: Cooktop Assembly
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. Spill tray • Remove the burner rings, burner caps and grates from their shipping packages. Stack burner •... -
Page 22: Verifying Proper Operation
Repeat the above bake test or burner ignition test. If the appliance still does not work, contact Dacor Distinctive Service at (877) 337-3226. Do not attempt to repair the appliance yourself. Have the model and serial numbers available when you call. - Page 24 Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com...