Loading The Film - Rollei PREGO 145 Instructions For Use Manual

Loading the film

1. To open the camera back, press the release button
as shown in Fig. 3.
2. Insert the film cartridge in the film compartment. Don't
use any force.
3. Pull out the leading edge of the film to the start mark
on the right side of the camera as shown in Fig. 4.
Keep the film flat.
• If you have pulled too much film from the cartridge,
remove the cartridge from the film compartment and
carefully wind back the film.
IMPORTANT:
Light may damage the part of the film on which the
first frame is exposed. As a precaution take two pho-
tographs of the first subject.
50
Display signaling film-loading-error
4. Close the camera back. Make sure you hear it click in
place.
5. The film is automatically advanced to the first frame.
The "film loaded" indication appears in the LCD panel.
6. Once the film has been advanced to the first frame,
<1EX> is displayed in the picture counter in the LCD
panel.
7. If < E > flashes in the LCD panel and the shutter re-
lease remains locked, that means the film was in-
serted incorrectly. Open the camera back and put the
film in again.
Observations
• With DX-coded films, the camera adjusts automati-
cally to the correct film speed between ISO 50 and
3200.
• If the film is not DX-coded, the camera automatically
sets a film speed of ISO 100/21 .