Table of Contents
Advertisement
Administering the WMIC
Command
Step 3
radius-server host {hostname |
ip-address} [auth-port port-number]
[acct-port port-number] [timeout
seconds] [retransmit retries] [key
string]
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
To remove the specified RADIUS server, use the no radius-server host hostname | ip-address command
in global configuration mode.
This example shows how to configure one RADIUS server for authentication and another for accounting:
bridge(config)# radius-server host 172.29.36.49 auth-port 1612 key rad1
bridge(config)# radius-server host 172.20.36.50 acct-port 1618 key rad2
This example shows how to configure host1 as the RADIUS server using the default ports for both
authentication and accounting:
bridge(config)# radius-server host host1
Purpose
Specifies the IP address or hostname of the remote RADIUS server host.
(Optional) For auth-port port-number, specify the UDP destination
•
port for authentication requests.
•
(Optional) For acct-port port-number, specify the UDP destination
port for accounting requests.
(Optional) For timeout seconds, specify the time interval that the
•
bridge waits for the RADIUS server to reply before retransmitting.
The range is 1 to 1000. This setting overrides the interval set using the
radius-server timeout command. If no timeout is set with the
radius-server host command, the time interval set with the
radius-server timeout command is used.
(Optional) For retransmit retries, specify the number of times a
•
RADIUS request is resent to a server if that server is not responding
or is responding slowly. The range is from 1 to 1000. If no retransmit
value is set with the radius-server host command, the value set with
the radius-server retransmit command is used.
(Optional) For key string, specify the authentication and encryption
•
key used between the bridge and the RADIUS daemon running on the
RADIUS server.
The key is a text string that must match the encryption key that is
Note
used on the RADIUS server. Always configure the key as the last
item in the radius-server host command. Leading spaces are
ignored, but spaces within and at the end of the key are used. If
you use spaces in the key, do not enclose the key in quotation
marks unless the quotation marks are part of the key.
To configure the bridge to recognize more than one host entry associated
with a single IP address, enter this command as many times as necessary,
making sure that each UDP port number is different. The bridge software
searches for hosts in the order in which you specify them. Set the timeout,
retransmit, and encryption key values to use with the specific RADIUS
host.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Cisco 3200 Series Wireless MIC Software Configuration Guide
Configuring and Enabling RADIUS
23
Hide quick links:
Advertisement
Table of Contents
