Enabling Cipher Suite; Enabling Cipher Suite With 12.4(3)Jk Or Later Releases - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Cipher Suites and WEP
Table 2
Key
Slot
Because the root device's WEP key 1 is selected as the transmit key, WEP key 1 on the non-root bridge
must have the same contents. WEP key 4 on the non-root bridge is set, but because it is not selected as
the transmit key, WEP key 4 on the root device does not need to be set at all.
Note

Enabling Cipher Suite

Enabling Cipher Suite with 12.4(3)JK or Later Releases

Cisco 3201WMIC with 12.4(3)JK or later releases moves cipher settings from dot11 interface to each
SSID configuration. Cisco 3202 WMIC and 3205 WMIC supports this feature change starting 12.4(3)JL
release.
To configure cipher suite encryption, follow these steps, beginning in privileged EXEC mode:
Command
Step 1
configure terminal
Step 2
dot11 ssid sample_ssid
WEP Key Setup Example
Root Device
Transmit? Key Contents
1 x 12345678901234567890abcdef
–
2 09876543210987654321fedcba
3 – (Not set)
4 – (Not set)
If you enable MIC but you use static WEP (you do not enable any type of EAP authentication),
both the root device and any non-root bridges with which it communicates must use the same
WEP key for transmitting data. For example, if the MIC-enabled root device uses the key in slot
1 as the transmit key, a non-root bridge associated to the root device must use the same key in
its slot 1, and the key in the non-root bridge's slot 1 must be selected as the transmit key.
Associated Non-Root Bridge
Transmit? Key Contents
–
x
–
–
Purpose
Enters global configuration mode.
Enters SSID Configuration.
Cisco 3200 Series Wireless MIC Software Configuration Guide
Configuring Cipher Suites
12345678901234567890abcdef
09876543210987654321fedcba
(Not set)
FEDCBA09876543211234567890
5