Disabling And Enabling Message Logging - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Configuring System Message Logging
Table 2
Feature
Timestamps
Synchronous logging
Logging server
Syslog server IP address
Server facility
Server severity

Disabling and Enabling Message Logging

Message logging is enabled by default. It must be enabled to send messages to any destination other than
the console. When enabled, log messages are sent to a logging process, which logs messages to
designated locations asynchronously to the processes that generated the messages.
To disable message logging, follow these steps, beginning in privileged EXEC mode:
Command
Step 1
configure terminal
Step 2 no logging on
Step 3
end
Step 4 show running-config
or
show logging
Step 5
copy running-config startup-config
Disabling the logging process can slow down the WMIC because a process must wait until the messages
are written to the console before continuing. When the logging process is disabled, messages are
displayed on the console as soon as they are produced, often appearing in the middle of command output.
The logging synchronous global configuration command also affects the display of messages to the
console. When this command is enabled, messages appear only after you press Return. For more
information, see the
To re-enable message logging after it has been disabled, use the logging on global configuration
command.
Cisco 3200 Series Wireless MIC Software Configuration Guide
4
Default System Message Logging Configuration (continued)
"Enabling and Disabling Timestamps on Log Messages" section on page
Default Setting
Disabled
Disabled
Disabled
None configured
Local7 (see Table 4 on page
Informational (and numerically lower
levels; see Table 3 on page
Purpose
Enters global configuration mode.
Disables message logging.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
System Message Logging
11)
8)
6.