Election Of The Spanning-Tree Root; Spanning-Tree Timers; Creating The Spanning-Tree Topology - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Understanding Spanning Tree Protocol

Election of the Spanning-Tree Root

All bridges in the Layer 2 network participating in STP gather information about other bridges in the
network through an exchange of BPDU data messages. This exchange of messages results in these
actions:
•
•
•
For each VLAN, the bridge with the highest bridge priority (the lowest numerical priority value) is
elected as the spanning-tree root. If all bridges are configured with the default priority (32768), the
bridge with the lowest MAC address in the VLAN becomes the spanning-tree root. The bridge priority
value occupies the most significant bits of the bridge ID.
When you change the bridge priority value, you change the probability that the bridge will be elected as
the root bridge. Configuring a higher value decreases the probability; a lower value increases the
probability.
The spanning-tree root is the logical center of the spanning-tree topology. All paths that are not needed
to reach the spanning-tree root from anywhere in the network are placed in the spanning-tree blocking
mode.
BPDUs contain information about the sending bridge and its ports, including bridge and MAC addresses,
bridge priority, port priority, and path cost. STP uses this information to elect the spanning-tree root and
root port for the network and the root port and designated port for each LAN segment.

Spanning-Tree Timers

Table 1
Table 1
Variable
Hello timer
Forward-delay timer
Maximum-age timer

Creating the Spanning-Tree Topology

In Figure
the default (32768) and bridge 4 has the lowest MAC address. However, because of traffic patterns,
number of forwarding interfaces, or link types, bridge 4 might not be the ideal spanning-tree root. By
increasing the priority (lowering the numerical value) of the ideal bridge so that it becomes the
spanning-tree root, you force a spanning-tree recalculation to form a new topology with the ideal bridge
as the spanning-tree root.
This graphic is pretty useless, as how does the user know which device is Bridge 4?
Book Title
4
The election of a unique spanning-tree root for each spanning-tree instance
The election of a designated bridge for every LAN segment
The removal of loops in the network by blocking Layer 2 interfaces connected to redundant links
describes the timers that affect the entire spanning-tree performance.
Spanning-Tree Timers
Description
Determines how often the bridge broadcasts hello messages to other bridges.
Determines how long each of the listening and learning states last before the
interface begins forwarding.
Determines the amount of time the bridge stores protocol information
received on an interface.
1, bridge 4 is elected as the spanning-tree root because the priority of all the bridges is set to
Spanning Tree Protocol in a Wireless Environment