Using Ftp To Access The Mib Files - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Using FTP to Access the MIB Files

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Using FTP to Access the MIB Files
Follow these steps to obtain each MIB file by using FTP:
Use FTP to access the server ftp.cisco.com.
Step 1
Log in with the username anonymous.
Step 2
Enter your e-mail username when prompted for the password.
Step 3
At the
Step 4
Use the get MIB_filename command to obtain a copy of the MIB file.
Step 5
Cisco 3200 Series Wireless MIC Software Configuration Guide
2
CISCO-PROCESS-MIB
CISCO-PRODUCTS-MIB
CISCO-SMI
CISCO-SYSLOG-MIB
CISCO-SYSLOG-EVENT-EXT-MIB
CISCO-TC
CISCO-TBRIDGE-DEV-IF-MIB
CISCO-WLAN-VLAN-MIB
ENTITY-MIB
IANAifType-MIB
IEEE802dot11-MIB
IF-MIB
INET-ADDRESS-MIB
OLD-CISCO-SYS-MIB
OLD-CISCO-SYSTEM-MIB
OLD-CISCO-TS-MIB
P-BRIDGE-MIB
Q-BRIDGE-MIB
RFC1213-MIB
RFC1398-MIB
SNMPv2-MIB
SNMPv2-SMI
SNMPv2-TC
SNMPv3-MIB
prompt, change directories to /pub/mibs/v1 or /pub/mibs/v2.
ftp>
Supported MIBs