Using The Cli - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

Resetting to the Default Configuration

Using the CLI

Follow the steps below to delete the current configuration and return all wireless device settings to the
factory defaults using the CLI.
Open the CLI using a Telnet session or a connection to the wireless device console port.
Step 1
Reboot the wireless device by removing power from and reapplying power to the router.
Step 2
Let the wireless device boot until the command prompt appears and the wireless device begins to inflate
Step 3
the image. When you see these lines on the CLI, press Esc:
Loading "flash:/c350-k9w7-mx.v122_13_ja.20031010/c350-k9w7-mx.v122_13_ja.20031010"
...###########################################################################
################################################################################
################################################################################
####################
At the ap: prompt, enter the flash_init command to initialize the flash.
Step 4
ap: flash_init
Initializing Flash...
flashfs[0]: 142 files, 6 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7612416
flashfs[0]: Bytes used: 3407360
flashfs[0]: Bytes available: 4205056
flashfs[0]: flashfs fsck took 0 seconds.
...done initializing Flash.
Use the dir flash: command to display the contents of flash and find the config.txt configuration file.
Step 5
ap: dir flash:
Directory of flash:/
3 .rwx 223 <date> env_vars
4 .rwx 2190 <date> config.txt
5 .rwx 27 <date> private.config
150 drwx 320 <date> c350.k9w7.mx.122.13.JA
4207616 bytes available (3404800 bytes used)
Step 6 Use the rename command to change the name of the config.txt file to config.old.
ap: rename flash:config.txt flash:config.old
Use the reset command to reboot the wireless device.
Step 7
ap: reset
Are you sure you want to reset the system (y/n)?y
System resetting..Xmodem file system is available.
flashfs[0]: 142 files, 6 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7612416
flashfs[0]: Bytes used: 3407360
flashfs[0]: Bytes available: 4205056
flashfs[0]: flashfs fsck took 0 seconds.
Reading cookie from flash parameter block...done.
Base ethernet MAC Address: 00:40:96:41:e4:df
Loading "flash:/c350.k9w7.mx.122.13.JA/c350.k9w7.mx.122.13.JA"...######## . . .
The wireless device is configured with factory default values, including the IP address (set to receive an
Note
IP address using DHCP) and the default username and password (Cisco).
Cisco 3200 Series Wireless MIC Software Configuration Guide
4
WIMIC Troubleshooting