Reloading The Image - Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual

WIMIC Troubleshooting
Step 8 When Cisco IOS software is loaded, you can use the del privileged EXEC command to delete the
config.old file from flash.
ap# del flash:config.old
Delete filename [config.old]
Delete flash:config.old [confirm]
ap#

Reloading the Image

If the wireless device has a firmware failure, you must reload the image file. If the wireless device
experiences a firmware failure or a corrupt firmware image, indicated by three red LED indicators, you
must reload the image from a connected TFTP server.
This process resets all configuration settings to factory defaults, including passwords, WEP keys, the
Note
wireless device IP address, and SSIDs.
Follow the steps below to reload the wireless device image using the CLI. When the wireless device
begins to boot, interrupt the boot process and use boot loader commands to load an image from a TFTP
server to replace the image in the wireless device.
Note
Open the CLI by using a Telnet session or a connection to the wireless device console port.
Step 1
Reboot the wireless device by removing power and reapplying power.
Step 2
Let the wireless device boot until it begins to inflate the image. When you see these lines on the CLI,
Step 3
press Esc:
Loading "flash:/c350-k9w7-mx.v122_13_ja.20031010/c350-k9w7-mx.v122_13_ja.20031010"
...###########################################################################
################################################################################
################################################################################
####################
When the ap: command prompt appears, enter the set command to assign an IP address, subnet mask,
Step 4
and default gateway to the wireless device.
Note
Your entries might look like this example:
ap: set IP_ADDR 192.168.133.160
ap: set NETMASK 255.255.255.0
ap: set DEFAULT_ROUTER 192.168.133.1
Step 5 Enter the tftp_init command to prepare the wireless device for TFTP.
ap: tftp_init
Your wireless device configuration is not changed when using the CLI to reload the image file.
You must use upper-case characters when you enter the IP-ADDR, NETMASK, and
DEFAULT_ROUTER options with the set command.
Cisco 3200 Series Wireless MIC Software Configuration Guide
Reloading the Image
5