Cisco C3201FESMIC-TP= - 3201 Fast EN Switch Mobile Interface Card Expansion Module Software Configuration Manual page 253

WIMIC Troubleshooting
Table 2 Error and Event Messages (continued)
Message
DOT11-6-ROGUE_AP: Rogue AP
[mac-address] reported. Reason: [chars]
SCHED-3-UNEXPECTEDMESSAGE:
Unknown message [hex] received (ptr
arg [hex], num arg [hex]).
SCHED-3-UNEXPECTEDEVENT:
Process received unknown event (maj
[hex], min [hex]).
Miscellaneous Messages
WGB_CLIENT_VLAN: Workgroup
Bridge Ethernet client VLAN not
configured.
UNDER_VOLTAGE: Under voltage
condition detected.
Explanation
A station has reported a potential rogue
bridge for the stated reason.
A process can register to be notified when
various events occur in the router. This
message indicates that a process received
a message from another process that it
does not know how to handle.
A process can register to be notified when
various events occur in the router. This
message indicates that a process received
an event that it did not know how to
handle.
A VLAN configuration is missing for
client devices connected to a workgroup
bridge.
The hardware under voltage detection
logic has reported a low voltage
condition.
Cisco 3200 Series Wireless MIC Software Configuration Guide
Error and Event Messages
Recommended Action
None.
Copy the error message exactly as it
appears, and report it to your technical
support representative.
Copy the error message exactly as it
appears, and report it to your technical
support representative.
Use the workgroup-bridge client-vlan
command to assign a VLAN to
Ethernet client devices connected to the
workgroup bridge.
Check the power supply and associated
power connections.
11