Access Point Specifications - Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual

Access Point Specifications

Access Point Specifications
The access point specifications are listed in
Table 1-1 Access Point Specifications
Category Access Point with 2.4-GHz Radio
Size 6.56 in. W x 7.23 in. D x 1.66 in. H
16.67 cm W x 18.36 cm D x 4.22 cm H
Status Indicators Three indicators on the top panel: Ethernet traffic, status, and radio traffic
Connectors Back panel (left to right): reverse-TNC antenna connector; power connector (for plug-in AC power
module); RJ-45 connector for 10BASE-T or 100BASE-T Ethernet connections; upside down RJ-45
connector for serial connections; reverse-TNC antenna connector.
Front Panel: Card Bus connector used for the 5-GHz radio module.
Input Voltage 48 VDC nominal. Operational up to 60 VDC. Voltage higher than 60 VDC can damage the unit.
Input Current With 2.4 GHz radio:
The access point is capable of drawing 380 mA depending upon the current radios and future radios
installed in the unit.
Operating Temperature Access point:
1200 series power injector:
Storage Temperature –40 to 185
Weight Without mounting bracket:
Power Output 100, 50, 30, 20, 5, or 1 mW
(Depending on the regulatory domain in
which the access point is installed)
Frequency 2.400 to 2.497 GHz
(Depending on the regulatory domain in
which the access point is installed)
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
1-10
125 mA (typical)
o o
–4 to 131 F (–20 to 55 C)
o o
32 to 104 F (0 to 40 C)
o o
F (–40 to 85 C)
1.6 lbs (0.73 kg) with 2.4-GHz radio
module
Table 1-1.
Access Point with 5-GHz Radio Module
With the 5-GHz antenna in the patch position:
6.56 in. W x 8.04 in. D x 2.21 in. H
16.67 cm W x 20.42 cm D x 5.61
With 5-GHz radio:
165 mA (typical)
With 2.4-GHz and 5-GHz radios
225 mA (typical)
Access point (with 2.4-GHz and 5-GHz radio):
o
–4 to 122 F (–20 to 50
1200 series power injector:
o
32 to 104 F (0 to 40
o
–40 to 185 F (–40 to 85
Without mounting bracket:
1.87 lbs (0.85 kg) with 5-Ghz radio module
1.97 lbs (0.89 kg) with 5-GHz radio module and
2.4-GHz radio
40 mW (16 dBm)
20 mW (13 dBm)
10 mW (10 dBm)
5 mW (7 dBm)
Note These values are based on the FCC peak
measurement method as defined in
FCC 15.407 (A)(4)
UNII 1—5.15 to 5.25 GH
UNII 2—5.25 to 5.35 GHz
(Depending on the regulatory domain in which the
access point is installed)
Chapter 1 Overview
o
C)
o
C)
o
C)
OL-2155-02