Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual page 62

Installing a 2.4-GHz Radio
Step 5 Insert the radio card into the access point's mini-PCI connector by following the steps below:
a. Tilt the radio card at approximately 20
connector (see
Push the card into the mini-PCI connector until it clicks into place.
b.
Carefully push the card down (towards the access point's motherboard) until the card-retaining clips lock
Step 6
into the notches on the side of the radio card (you will hear a click).
Carefully position the antenna wires so that the metal connectors do not touch each other.
Step 7
Damage to the radio could occur if the antenna connectors are touching when power is applied. If they
Caution
are touching, carefully rotate them in opposite directions until they are separated.
Reinstall the 2.4-GHz radio access cover and use the T-10 tamper-resistant Torx L-wrench to tighten the
Step 8
cover's retaining screw.
Remove the backing paper from the 2.4-GHz radio product compliance label.
Step 9
Carefully attach the label in the space provided below the access point's product compliance label as
Step 10
shown in
Figure 5-5
1
2.4-GHz radio product compliance label
Note
The radio card installation is now complete. To configure the 2.4-GHz radio card with your wireless
network settings refer to the Cisco Aironet 1200 Series Access Point Software Configuration Guide.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
5-8
Figure 5-4).
Figure 5-5.
Location of Product Compliance Labels
If your access point contains a 5-GHz radio module, there will also be a 5-GHz radio product
compliance label on the back of the unit.
o o
to 30 so that its gold pins are aligned with the mini-PCI
1 2
2
Access point product compliance label
Chapter 5 2.4-GHz Radio Upgrade
OL-2155-02