Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual page 60

Removing a 2.4-GHz Radio
Step 2 Remove the 2.4-GHz radio card from the mini-PCI connector by performing the following operations:
a. Push the card-retaining clips (on each side of card) away from the card (see
released, the radio card springs up (see
Figure 5-3
1
b. Grasp the radio card only on the edges, being careful not to touch components on the board or the
gold connector pins.
c. Remove the 2.4-GHz card from the mini-PCI connector.
Step 3 Place the removed 2.4GHz radio card into an anti-static bag.
For instructions on installing a new radio card, go to the
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
5-6
Location of Retaining Clips on 2.4-GHz Radio Card
1
Card-retaining clips
Figure 5-4).
1
MAIN AUX
"Installing a 2.4-GHz Radio"
Chapter 5 2.4-GHz Radio Upgrade
Figure 5-3). When
section.
OL-2155-02