Indicators - Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual

Chapter 1 Overview

Indicators

The three indicators on top of the access point report Ethernet activity, association status, and radio
activity as shown in
Figure 1-1
•
•
•
The Radio and Status indicators are used for both 2.4-GHz and 5-GHz radio operation.
Note
OL-2155-02
Figure 1-1.
Indicators on the 1200 Series Access Point
The Ethernet indicator signals Ethernet traffic on the wired LAN. This indicator blinks green when
a packet is received or transmitted over the Ethernet infrastructure. The indicator blinks red when
the Ethernet cable is not connected.
The association status indicator signals operational status. Blinking green indicates that the access
point is operating normally but is not associated with any wireless client devices. Steady green
indicates that the access point is associated with at least one wireless client device.
The radio indicator blinks green to indicate radio traffic activity. The light is normally off, but it
blinks green whenever a packet is received or transmitted over the access point radio.
Radio
Status
Ethernet
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Key Features
1-5