Removing A 5-Ghz Radio Module - Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual

Chapter 6 5-GHz Radio Module Upgrade
Step 3 Remove the 5-GHz access cover (see
Figure 6-1
1

Removing a 5-GHz Radio Module

To remove the 5-GHz radio module, follow the instructions below:
Step 1 Remove all cables and power connections from the access point.
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.
Unscrew the two mounting screws using the supplied Torx L-wrench
Step 3
Figure 6-2
1
2
Note
OL-2155-02
5-GHz Radio Access Cover
1 2 1
Access Cover Screws
5-GHz Radio Module
1 1 2
Mounting screws
5-GHz radio module antenna
Do not attempt to remove the mounting screws from the module; they are captured in the module
housing.
Figure 6-1) using the supplied Torx L-wrench.
2 Access Cover
3
3 Access point
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Removing a 5-GHz Radio Module
(Figure 6-2).
6-3