Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual page 75

Chapter 7 Troubleshooting
Step 2 Open a terminal-emulation program on your computer.
Note
Step 3 In the Connection Description window, enter a name and select an icon for the connection and click
OK.
Step 4 In the Connect To window, select the port to which the cable is connected and click OK.
In the Port Settings window, enter the following settings:
Step 5
Bits per second (baud rate): 9600
•
Data bits: 8
•
Parity: No parity
•
• Stop bits: 1
• Flow control: Xon/Xoff or None
Step 6 Click OK, and press Enter.
Step 7 When the Summary Status screen appears, reboot the access point by unplugging the power connector
or the Ethernet cable (when using in-line power) and then plugging it back in.
Step 8 When the access point reboots and the Summary Status screen reappears, type :resetall, and press Enter.
Step 9 Type yes, and press Enter to confirm the command.
The resetall command is valid for only 2 minutes immediately after the access point reboots. If you do
Note
not enter and confirm the resetall command during that 2-minute period, reboot the access point again.
After the access point reboots and the Express Setup screen appears, reconfigure the access point by
Step 10
using the terminal emulator or an Internet browser.
OL-2155-02
These instructions describe Microsoft HyperTeminal; other programs are similar.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Resetting to the Default Configuration
7-5