Overview
Overview
This section provides instructions for upgrading the access point 2.4-GHz radio. The following
operations summarize the upgrade procedure:
•
•
•
•
•
•
•
•
Caution
ESD can damage the Cisco Aironet radio and the internal components of the access point. It is
recommended that the 2.4-GHz radio upgrade procedures be performed by an ESD-trained service
technician at an ESD-protected workstation.
Unpacking the Radio
Each 2.4-GHz radio is shipped with the following items:
•
•
•
•
If anything is missing or damaged, contact your Cisco representative for support.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
5-2
Remove all cables and power connections from the access point.
Follow standard electrostatic discharge (ESD) procedures .
Place the access point on an ESD-protected work surface.
Open the access point's 2.4-GHz radio access cover.
For an access point without the 2.4-GHz radio feature, remove the blank spacer card.
For an access point with the 2.4-GHz radio feature, remove the existing 2.4-GHz card.
Install the new 2.4-GHz radio card.
Close the access point 2.4-GHz radio access cover.
Quick start guide
A product registration card
A T-10 tamper-resistant Torx L-wrench
A 2.4 GHz radio product compliance label
Chapter 5
2.4-GHz Radio Upgrade
OL-2155-02