Chapter 6 5-Ghz Radio Module Upgrade; Overview; Unpacking The Radio Module; Removing The 5-Ghz Radio Access Cover - Cisco AIR-AP1220B-A-K9 - Aironet 1200 - Wireless Access Point Hardware Installation Manual

Overview

Overview
This section provides instructions for upgrading the access point 5-GHz radio module. The following
operations summarize the upgrade procedure:
1.
2.
3.
4.
5.

Unpacking the Radio Module

Each 5-GHz radio module is shipped with the following items:
•
•
•
•
If anything is missing or damaged, contact your Cisco representative for support.

Removing the 5-GHz Radio Access Cover

To remove the 5-GHz radio access cover, follow the instructions below:
Step 1 Remove all cables and power connections from the access point.
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
6-2
Remove all cables and power connections from the access point.
Place your access point on a flat surface.
For an access point without the 5-GHz radio feature, remove the 5-GHz radio access cover.
For an access point with the 5-GHz radio feature, remove the existing 5-GHz radio module.
Install the new 5-GHz radio module.
Quick start guide
A product registration card
A T-10 tamper-resistant Torx L-wrench
A 5-GHz radio product compliance label
Chapter 6 5-GHz Radio Module Upgrade
OL-2155-02