Protocols And Standards; Configuration Task List - H3C S9500 Series Operation Manual

Operation Manual – MSTP
H3C S9500 Series Routing Switches
TC-BPDU guard
Support for hot swapping of interface cards and active/standby changeover.

1.1.3 Protocols and Standards

MSTP is documented in:
IEEE 802.1D: Spanning Tree Protocol
IEEE 802.1w: Rapid Spanning Tree Protocol
IEEE 802.1s: Multiple Spanning Tree Protocol

1.2 Configuration Task List

Before configuration, you need to know the position of each device in each MSTI: root
bridge or leave node. In each instance, one, and only one device acts as the root bridge,
while all others as leaf nodes.
Configuring
the Root
Bridge
Task
Configuring an MST Region
Specifying the Root Bridge or a Secondary Root Bridge
Configuring the Work Mode of MSTP Device
Configuring the Priority of the Current Device
Configuring the Maximum Hops of an MST Region
Configuring the Network Diameter of a Switched
Network
Configuring Timers of MSTP
Configuring the Timeout Factor
Configuring the Maximum Transmission Rate of Ports
Configuring Ports as Edge Ports
Configuring Whether Ports Connect to Point-to-Point
Links
Configuring the Mode a Port Uses to Recognize/Send
MSTP Packets
Enabling the MSTP Feature
1-18
Chapter 1 MSTP Configuration
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required