Booting Process - H3C SECPATH F100-A,SECPATH F100-A HOST,A Installation Manual

Installation Manual
H3C SecPath F100-A Firewall
III. Checking after power-up
After the firewall is powered up, please check:
The LEDs on the front panel are normal.
Refer to section 1.2.3 "LEDs" for the LED description.
The console terminal display is correct.
After powering up the firewall, you can see the startup window on the console terminal
(see section 4.1.3 "Booting Process"). After the startup (or power-on self-test), you are
prompted to press <Enter>. When the prompt <H3C> appears, the system is ready for
your configuration.

4.1.3 Booting Process

After being powered up, the firewall first runs the Boot ROM program. The terminal
screen displays the following system information.
Note:
The contents displayed on the terminal may vary with Boot ROM versions.
**************************************************
*
*
*
**************************************************
Copyright(C) 2004-2007 by Hangzhou H3C Technologies Co.,Ltd.
Compiled at Wed Apr 12 17:39:36 CST 2006
Testing memory...OK!
256M bytes DDR SDRAM Memory
16M
Hardware Version is 3.0
CPLD
Press Ctrl-B to enter Boot Menu
Press <Ctrl+B> right now and the system will enter the Boot menu. Otherwise, the
system will start the program decompression process.
H3C SecPath Series Gateway Boot ROM V1.17 *
bytes Flash Memory
Version is 1.0
Chapter 4 Firewall Configuration
4-5
*
*