Figure 5-4 Set Up The Remote Upload/Download Environment - H3C SECPATH F100-A,SECPATH F100-A HOST,A Installation Manual

Table of Contents

Installation Manual

H3C SecPath F100-A Firewall

Step 1: Connect the PC to the Ethernet port of firewall.

Step 2: Configure the IP address of the Ethernet port of firewall. Here suppose it is

10.110.10.10.

Step 3: Configure the IP address of the PC. Here suppose it is 10.110.10.13.

Step 4: Copy the application, Boot ROM program or configuration files to a specific path.

Here suppose the path is C:\\ version.

Caution:

The network port IP address of the PC must be in the same network segment with that

of the Ethernet port of the firewall.

Setting up the remote upload/download environment

10.110.20.13/24

(FTP Client)

Figure 5-4 Set up the remote upload/download environment

Step 1: Connect the PC through WAN to any interface of the firewall. The IP addresses

of the PC and the firewall can be in different network segments.

Step 2: Copy the application, Boot ROM program or configuration files to a specific path.

Here suppose the path is C:\\ version.

II. Booting FTP server

Ask the technical personnel at the firewall side to make the following configuration:

Step 1: Configure authentication mode.

Note:

You can perform AAA authentication configuration as needed. See the AAA and

RADIUS configuration part in the Operation Manual and Command Manual of the

corresponding product for details.

WAN

Router

5-9

Chapter 5 Software Maintenance

H3C SecPath F100-A (FTP Server)

Ethernet interface

10.110.10.10/24

Table of Contents

Do you have a question about the H3C SECPATH F100-A,SECPATH F100-A HOST,A and is the answer not in the manual?