Figure 7-1 Install The Mim I; Figure 7-2 Install The Mim Ii - H3C SECPATH F100-A,SECPATH F100-A HOST,A Installation Manual

Table of Contents

Installation Manual

H3C SecPath F100-A Firewall

Step 3: Select a slot and push the MIM into the chassis until it is fully seated in the slot

and its front panel is flush with the front of the chassis.

Step 4: Tighten the captive screws to secure the MIM.

Step 5: Power up the firewall and check the state of the ACT LED for the slot on the

firewall. Blinking means the MIM is installed correctly.

Figure 7-1 Install the MIM I

III. Removing an MIM

Step 1: Place the firewall with its front panel facing you.

Step 2: Turn off the site power and remove the power cord.

Step 3: Remove all interface cables from the front of the chassis.

Step 4: Loosen the captive screws at both sides of the MIM.

Step 5: Pull the MIM towards you until it is completely separated from the bottom of the

chassis.

Caution:

If you remove an MIM and do not install a new one right away, you must replace the

blanking filler panel to prevent dust from entering the firewall and to provide

adequate ventilation.

Do not operate at MIMs near the passageway to avoid accidents to the unit or the

removed MIMs.

7-2

Chapter 7 MIM Modules

Table of Contents

Do you have a question about the H3C SECPATH F100-A,SECPATH F100-A HOST,A and is the answer not in the manual?